The RV-M8 series of OEM radio modems is configured to easily be integrated into OEM products.
The 20 pin UWORC connector is a standard data radio modem pin out used on all Raveon OEM radio modems.
A PDF describing the UWORC is here.
The 20-pin connector has male pins to plug into your PCB.
The male connector on the radio modem is a 20-pin 2mm header.
PinOut
This Radio with the UWORC connector is easy to design into your product. A;; Raveon OEM radios use this connector pin-out so you can use any or all of our radios in you rroducts.
The following table details a UWORC’s pin function and detailed implementation on supported hardware:
| Pin No. | Name | I/O | Type | M8 | M8/M6 Daisy(VHF, UHF, UHF+) | D50/Z50Daisy (LoRa and 3G/4G) |
| 1 | GND | Ground | ||||
| 2 | VIN | I | 12-30V | 12-30V(5V without –V option) | ||
| 3 | CD | O | Dig | Carrier Detect | ||
| 4 | TX_ON | O | Dig | Transmitter On Indicator | ||
| 5 | RX | I | Dig | UART Receive Data | ||
| 6 | TX | O | Dig | UART Transmit Data | ||
| 7 | EN | I | Dig(Up to Vin) | Enable, Active HighPulled up to Vin with 1Mohm Enable when >2.0V | ||
| 8 | DTR/SLEEP/ U2_Rx | I | Dig | Selectable:Data Terminal Ready Sleep (Active High) UART 2 Input | ||
| 9 | CTS | O | Dig | Clear To Send UART Handshaking | ||
| 10 | RTS | I | Dig | Ready To Send UART Handshaking. Used to stop/start the flow of data output. 0 = OK to send, 1 = don’t send. Leave disconnected if not used. | ||
| 11 | RSSI | O | Analog | Receive Signal Strength Indicator | Unused(Tied to Pin 17) | |
| 12 | 3_3V | O | 3.3V Output | |||
| 13 | IO_A/A_IN/ U2_Tx | I/O | Dig/Analog | Selectable:IO_A Digital Functions Analog/Audio Input UART 2 Output | ||
| 14 | IO_B/USB_DM | I/O | Dig | Selectable:IO_B Digital Functions USB Negative Line | ||
| 15 | IO_C/USB_DP | I/O | Dig | Selectable:IO_C Digital Functions USB Positive Line | ||
| 16 | STAT1 | O | Dig | Status 1 LED Indicator Output20mA LED Drive Capable | ||
| 17 | A_OUT | O | Analog | Analog/Audio Output | ||
| 18 | STAT2/BLOAD | I/O | Dig | Status 1 LED Indicator Output20mA LED Drive Capable At power-on (VIN and EN), pull to 3.3V to activate primary bootloader | ||
| 19 | GND | Ground | ||||
| 20 | V_BU | I | Backup Voltage3.3V Maximum Leave unconnected if unused | |||
